Extended BLTouch Mount

thingiverse

Extended the BLTouch Mount to work with a different Satsana fan shroud Edit- I had to drill a hole through the back of the bracket and place a screw and nut through it to hit the X limit switch as the mount was colliding with the X axis motor housing before the hotend bracket could make contact with the X limit switch. Not ideal, so I'll be updating the design tomorrow to have the bracket push out (towards the front of the printer) so the bracket doesn't collide with the housing anymore. I also had to place two M-3x.50 nuts between the BLTouch and this bracket to get the BLTouch to the correct height- then set the z offset distance to 2.51 and it put the nozzle (with the bed heated to 60 and the microswiss hotend to 235) exactly .038 distance between the nozzle and the buildplate. Edit- Added a spacer to go behind the mount. I was going to put two round spacers coming off the pack of the holes, but I thought that would make it difficult to print. So I figured a separate plate/spacer would be the easiest route :) Going to print it now and test it, but it should allow the bracket to clear the housing of the X axis motor so the limit switch connects with the hotend bracket again.