Extended 1/2 PVC roof and gutter dovetail clips for pixels

thingiverse

I tried the original but my shingles over hang the fascia on my house so I was not able to slide the dovetail into the base. I did notice before I placed them on my house, that the wires for my 2 inch spaced nodes were going to be in the way. I increased the base so that the dovetail slot was not quite past my shingles to help hold it in place, but still able to slide them together. I then increased the length of the PVC holder so that my pixel wires gave just enough tension on the fascia to hold it but not push it out of the clip. I grouped them together in one file to print them matched, and included separate files for each just in case you only needed to print one of the parts. You will need to print the base section vertical on your bed.