EXOYI *remix*

prusaprinters

<p>This is my personal remix to the case that DVegaman posted for the Xiaomi Yi. I widened the hole for the lens to allow the lens protector to push in tight. I also raised the top and bottom lens shrouds to add a bit more protection to the lens. I ended up having to make a 2nd version as super view would get part of the shrouds in view. I only run the superview script on mine so I'm not sure if the v1 will be ok without running the script. If you try it and it is let everyone know in the comments. There are a few other fixes with the case that I fixed as it was not fully level on the back. Thanks again to DVegaman for posting the original.</p> <p>V1.5 - non-superview<br/> v2 - superview</p> <h3>Print instructions</h3><h3>Category: Camera Summary</h3> <p>This is my personal remix to the case that DVegaman posted for the Xiaomi Yi. I widened the hole for the lens to allow the lens protector to push in tight. I also raised the top and bottom lens shrouds to add a bit more protection to the lens. I ended up having to make a 2nd version as super view would get part of the shrouds in view. I only run the superview script on mine so I'm not sure if the v1 will be ok without running the script. If you try it and it is let everyone know in the comments. There are a few other fixes with the case that I fixed as it was not fully level on the back. Thanks again to DVegaman for posting the original.</p> <p>V1.5 - non-superview<br/> v2 - superview</p> <h3> Print Settings</h3> <p><strong>Printer:</strong> Wanhao Duplicator i3</p> <p><strong>Rafts:</strong> No</p> <p><strong>Supports:</strong> Yes</p> <p><strong>Resolution:</strong> .25</p> <p><strong>Infill:</strong> 35%</p>