Exo El Capitan Slider Side Tray Electronics Tray

thingiverse

This design is for sliders/electronics trays/side trays for an Exo RC El Capitan chassis. I was inspired by electroz's TGH/Gspeed sliders, especially the battery strap slot design, so I posted this as a remix. However, this is an entirely new design specifically for the Exo El Capitan. There are separate STLs for with and without the battery strap slot. Make sure to print a LH and RH side. For this application PLA works fine. I either print at 60% infill and 8 walls or 100% if I don't mind the extra time and filament. Print on the flat side that goes against the chassis. You shouldn't need any supports. There is a small section that your printer will need to bridge for the battery strap design, but I haven't had problems with a mostly stock Ender 3. Note, the license is non-commercial. Please contact me if you want to print these for resale. Otherwise, have at for personal use.