EXIT Triker Pro100 Flagholder

EXIT Triker Pro100 Flagholder

thingiverse

Additional information and photos will be added soon. (Gibberish will be removed and nearly proper sense will be added too.) This is a spare part for the 'EXIT! Triker Pro 100'. The visibility flag holder, which is located on the rear left axle, rusted away and needed replacement. Hence I plan to integrate also a rear light at my son's Triker. I replaced the entire lower end cap of the frame, the one without a reflector. This part fits very tight and needs some careful hits to secure it fully in the frame. It is this tight by choice, as the first one sat tight but was too flimsy and fell out while my son was in 'stunt mode'. In the design of this replacement, there is a hole where a bolt could be inserted. On this bolt/pole I put some rubber rings and slid a small aluminum pipe over it. I had some orange truck tarp, cut two small slots in the near corners on one side, inserted the pipe/pole through the first one, inserted another bolt with a washer through the second slot, added another washer, and put that assembled bolt into the top end of the aluminum pipe.

Download Model from thingiverse

With this file you will be able to print EXIT Triker Pro100 Flagholder with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on EXIT Triker Pro100 Flagholder.