Evolve All Terrain (AT - 175mm wheels) mudguards

thingiverse

Want to stop getting drenched with road grime when cruising your Evolve GT over damp pavement? This is the way to go, it covers the wheel as closely as possible to prevent water and sand from flicking up onto you or the board from the AT wheels! It will extend the times when you can ride comfortably on your board, no longer getting soaked when gliding through a puddle! They also fit seamlessly with the look of the board! Give them a try and see what you think. They take about 10 hours each to print on my FlashForge Dreamer, so a total of 40 hours of printing time, but it's one of the greatest upgrades I've made for the board. The rear of this model attaches directly to the existing mount plate. If you have access to a mill or 3D mill, check out my design for the replacement rear plate and a rear guard that attaches to it at: https://www.thingiverse.com/thing:3816139 This design has been created with a focus on making it structurally strong without needing many additional components. You'll also need to purchase: - 8 M4 20mm bolts - 4 M4 locknuts - 8 M4 washers (smaller than 8mm diameter) - 4 M4 spring washers (smaller than 8mm diameter) - Thin double-sided tape for mounting the front mudguard to the axle (I used command strips) Assembly is pretty straightforward: The rear mudguards replace the cover for the pinion gear and belt, held on with 2 M4 bolts (put the spring washer on first and then the normal washer). Be careful when mounting so that you thread them in correctly. The front mounting bracket needs some double-sided tape to keep it from moving, put the tape on the two sides of the clamp, and position correctly on the shaft so that the wheel has sufficient clearance (I marked the position with a permanent marker before sticking on). Once the clamp is in place, mount using two bolts (with a washer each) to each clamp, and fasten with a locknut.