Evergreen Board Game Playable Insert

prusaprinters

I made these organizers to fit in the existing insert for Evergreen. Simply open the boxes and get playing! There are variations of each box so mix and match however you like. I like to have two sets of resources for everyone to reach better, but you can print one box for each type also. The lids of the small square boxes are all interchangeable. The large box lid is slightly different from the card box, but you should be able to tell them apart. Sleeved with Sleeve Kings 63.5x88 card sleeves. The lid should be snug, but easily removed. Print one small lid, and if it is too tight follow these steps: Unlock scaling (important), then increase the X dimension by .1mm, and the Y dimension by .1mm. Do not change the Z. Print again. If it is still too tight do the same thing increasing by .2mm. These lids print perfectly as is on my Prusa MK3S+, but need .2mm clearance on my CR-10. Find what works best for your printer! All lids can then be printed at the same tolerance you found before. If you have any problems message me!Happy Gaming!Check out my other board gaming designs here on Printables! I have designs for Honey Buzz, Project L, Isle of Cats, WILD Serengeti, Draftosaurus, Copenhagen and Witchstone available at my Etsy shop Taylor Jane Design Co.