Evenflo Soft and Wide gate replacement ends

thingiverse

These are replacement plastic ends. I printed on an Ender 3v2, .28 layer height, no supports, 50% gyroid infill. The rubber end area had a small amount of spaghetti because the lack of supports, easily cleaned with a knife. The rubber ends from the original will fit these. If you don't have the rubber ends you can probably improvise with a big glob of hot melt glue. Remove the old caps with dykes or a hacksaw, a hacksaw where the blade extends works best. These press fit on the tubes with some work, sand or file a little if necessary. UPDATE: I added a second cap for the other side (evenflo_narrowtube.stl), I have not printed/tested because my originals are fine, so let me know if they work.