EV100 PRO58 Module Mount

thingiverse

# EV100 PRO58 Mount This is my custom design to mount the PRO58 receiver on the Eachine EV100 goggles. I tried out some available designs but they didn't impress me so I came up with one of my own. The only non-3D printable parts needed are: * A 10mm long M3 screw * An M3 nut * A nut from an SMA pigtail, approximately 8mm in length ## Mounting Instructions First, secure the module to the case by tightening the locking mechanism. Next, connect the three wires: positive, ground, and signal. Then, insert the EV100 SMA through the 3D printed part. To attach the case to the goggles, use a pigtail nut or any other nut with matching threads. The recommended printing settings are below and supports are not necessary. I hope you find this design helpful. If you end up using it, please share a photo so I can see how it turns out!