EV Charger Type 2 Slightly Oversized FlashForge Finder printable

thingiverse

I took atlemo's charge plug holder and resized the base so that it will fit an 140*140mm FlashForge Finder base perfectly. Then I oversize it just a tad so it doesn't fit too tightly. After printing, I lay in a small strip of hot melt at the bottom. This gives it just enough friction to hold it snugly in place. The second version looks even better on the wall as it has its mounting screws hidden from view. Use the center hole to add a fifth screw or nail to stop it from gliding upwards when inserting the charge plug. Version 3 October 2018: I noticed during the long hot summer that the PLA had expanded and then contracted, so it gripped too tight now that autumn had come. Because of this, I made a version which is larger and doesn't depend on a tight fit to hold the charger handle. Instead, it has a little notch and a few ribs gripping it securely. This version is marked by a C. I also fixed the screw-hole-distance bug in this version. P.S. If you have a plug-in hybrid, live in a cool climate, and have an electric engine pre-heater/car heater, I made a combo version which allows for both cables to be protected in the same holder.