European Pegboard Hanger (Biltema)

thingiverse

These holders are designed for pegboards available at Biltema stores throughout Scandinavia. Pegboards can be screwed into place, but a more modular option was desired, and visible screw holes were not acceptable. One fits over Ikea kitchen cabinet doors. Another has 3mm holes for screws or nails. For vertical placement use this option. Check out mgx's pegboard wizard at http://www.thingiverse.com/thing:537516 to create various holders. The printer used is a Wanhao i3. Rafts are not necessary, and supports are not required. A resolution of 0.25mm is preferred. Infill settings range from 15% to 50%. Two perimeter shells are recommended. Infill strength depends on the application. Typically, 30% fast honeycomb in Simplify3d is used for added support.