EuroCradle - Eurorack Single Module Case

thingiverse

I needed a simple enclosure to house my Eurorack module while I work on its development. The central component is 18U wide, but you can simply scale it up or down to accommodate bigger or smaller modules. There are two variants of the central component. One has an opening in the back to attach a power cable and any other cables (such as an IC programmer) - it prints with a support tab in place which you can break away after printing. The other one is solid, and you can drill your own hole to accommodate a power input jack. If you want to fix the module to the case, you a 2.5mm drill and drill holes where your modules screw holes are located, then use an M3 screw to fix it in place. The screw will self-tap into the plastic without problems