EufyCam 2K Pan & Tilt Wallmount

thingiverse

Just print the mount upside down with supports, and you're done! No post-processing was done in the printed item as seen in the photo. I just printed at 0.2 nozzle width, set infill to 40%, and enabled supports to prevent the screw hole sagging. Which were easily broken off. In order to easily drill into the wall print the "Drill guide" to easily make your marks. And since they're close together, make sure you have a good drill bit to prevent tearout in the wall. I've mounted them with two screws with 6mm wall anchors. The EufyCam camera uses a default.1/4 inch tripod head screw in the (original) mount, just hang it under the mount, and insert the screw from the top. Then the camera will click into place. Use the "Screw tester" file to ensure that the screw you use fits perfectly and sits flush. Both the test files can be printed at just 5% infill to get them out in a matter of minutes