Eufy Robovac 11 30 Broom Gear Replacement

thingiverse

I printed several times this gear and broke, so I was tired of doing this over and over again, so I re-maked with a different approach, lower shatf hole, solid broom holder You will need to use a dremel to alter the holes on the brooms so it can fit in this design. Don´t drill too much so it can enter by pressure. This round design will spread the axial load more efficiently. It wont be as OEM, won't look great, but **IT WON'T BREAK**. Is really hard to buy one of these motors, so, If this helped feel free to share, print and use at your will. Be sure it have the following measures: X:23.55mm Y:23.55mm Z:13.00mm Print the washer to put below the gear. The 3mf have the project for Prusa Slicer *Ender 3* 0.2 Print Width, 0.4 Extruder, **Gear (bottom part)** 0.3 layer height, 20% infill, 3 walls **Broom Holder** 0.18 layer height, 0% infill, 15 walls Enyou