ETS ATS truck shifter

prusaprinters

shifter knob for ETS or ATS for TH8A. Diameter: 55mm. 2 snap-in switches for range / splitter or only range and motor break or like ever you want Model is split in 3 parts for easy printing and assembly Modification of TH8A needed: the rod has to replaced due to the non standard 9mm thread on upper end. I replaced it by an M6 rod and covered it for design reasons with a 8mm stainless steel pipe. The interface to the knob is a 12mm brass rod with M6 thread inside which is fixed by a M6 grub screw. This makes it easy to allign the knob in a propper position. Print Settings Printer Brand: Wanhao Printer: Duplicator 6 Rafts: No Supports: Yes Resolution: 0,2 Infill: 15% Filament: dont matter ABS Notes: Material list beside printing material: M6 rod (length like you want) stainless steel pipe OD8mm ID6mm; about 35mm shorter then rod 12mm brass rod, about 200mm long with M6 thread inside grub screw M6 nut M6 rectangular Marquardt switches (Type 1811 or 1813; on-off or on-on so 2 fixed positions) Arduino Leonardo or any other joystick simulator interface 3D printing settings ABS (others will work too) layer 0.2mm 15% infill support needed for upper and middle part Category: Games