Eternal Palace Deluxe Organiser

thingiverse

Eternal Palace by Alley Cat Games has an organiser for the canvas parts but nothing for the rest of the bits.... so I came up with this. All the holders are the same height, or add up to the height of the Canvas tray so the board and rule book fit on top along with the Labyrinth & River Market tiles and the "new" or cardboard easels. EP-Card Holder - Holds main card deck and solo cards - I'm using Sleeve Kings 63.5x88mm Sleeves. EP - Component Box - Holds Wood, Kaolin, Bronze and Wisdom tokens - including x5 tokens EP - Component Box 2 - Holds Fish, Stone, Feature Tokens, Seals and Prizes EP - Component Lid - Slide on lid for the Component boxes - print (in Cura) using no top and bottom layers, 8mm infill distance, Triangle Pattern and [30,30] line directions - see photo. If Storing horizontally you don't need the lids. EP-Locations Tray - holds the 5 Location expansion tiles - print the same as the lid. Ep-Monument Holder - holds the Monument mini's and tiles. EP-Privilege Tokens - holds the tokens for the Privilege expansion - these can be stored in Component Box 2 if you combine the Prizes and Feature tokens. I just wanted to keep the expansion separate to the main bits. EP-Small Card Holder - holds all the expansion cards (Privileges, River market and Compositions) with or without sleeves EP-Player Box - 5 slot drawer holder for the player drawers. EP-Player Drawer - Print 5 times preferably in each player colour - holds the 5 dice and 15 tokens for each player. EP - Mini Player Tray - Not needed but print 5 times in player colour if wanted- just lets you lift out the player tokens to set up the easel quicker. EP - Easel - Replaces the easily damaged cardboard easels - print 5 times - clips into the player drawer to stand up. The scoop at the front will hold about 13 canvas pieces so should be enough. I printed this at 100mm/s so it's not the smoothest of prints in the photos. There are quite a lot of bits - I've tried to keep the material usage down but it's still quite a bit. ****STL's are output from Fusion 360 so they are not oriented properly to the print area :( ****