Esun Filament Spool Drawers

thingiverse

If you ever wanted to find a purpose for your empty Esun brand filament spools, print these parts to turn them into mini-drawers! Any quality/layer size should work, i've done them at 0.28mm previously. The holes for the hinges may be too small on the spool as they can vary in size ( on my spool it fits 3 of the 4 holes but other hole is too small), so if this happens shave the hole with an Exacto knife or similar tool until the hinges can fit in. You will need to print 4 drawers (two of them mirrored from this STL), four Hinge and 2 Hinge Opposite Clip per spool of drawers. I've sliced the hinges lengthwise for easier printing and to align layers to the length for strength, you will need 2 prints of them for 1 set of hinges ( 4 prints total for a spool). You can squeeze them in side by side into the holes and they should stay there just fine. If the hinge opposite clip tends to fall out, just apply a little glue to it (any glue should do, the load on it should be minimal)