Estes Der Red Max nosecone (PNC-60AH)

thingiverse

I wasn't satisfied with the accuracy of some other models of this nosecone so I set out to make one of my own. I compared and measured a lot from my Der Red Max rocket to make this one as close to perfect as possible, and I expect any deviations are far too small to be seen by the naked eye. I've included versions with and without the shoulder, both solid and hollowed out. Feel free to use them to make remixes if you like. You could print the solid one with 0% infill but the result will likely be heavier than using the hollow one, and the very tip may be a bit weak. Using the same slicer setting the hollow cone with shoulder used under 30g or material, while the solid version with no infill and 3 walls came in at nearly 90g. The threaded hole at the bottom will accept an M8 bolt. You can use that to add weight temporarily if you like. Here is the Tinkercad link: https://www.tinkercad.com/things/ea63mX1o82f