Estacion de carga - mobile charging station

thingiverse

This base charger is based on the Aukey multi-port loader with six outputs that you can find at http://amzn.eu/f7blUTt, although any similar-sized one will do. To make the charger, you'll need an 8mm rod that will hold the plates we're going to print. There are three different types of plates to print: two of them have a base to attach to the charger at its ends. One type is for charging station 03-I base support I, and the other for charging station 03-I base support II. Then, you'll need to print five pieces of charging station 03-I medium. Finally, there's one piece for cable organizer: charging station 03-I bobina. The assembly is very simple; just cut the 8mm rod to the desired length and attach the parts, keeping in mind where the charger will go.