ESPixNode Case w/PG7 and 5.5mm x 2.1mm DC Jack

thingiverse

Remixed from hitekstuff's design, with several enhancements added for improved functionality and aesthetics. To ensure a snug fit, nubs were strategically placed to snap the board into place. The orientation of the mounting hole was reversed to accommodate specific requirements. A full enclosure was added to provide maximum protection, along with a hole for the PG7 gland that facilitates pigtail output. Additionally, a 5.5mm x 2.1mm DC Jack was installed, as specified by Amazon product B01N8VV78D. The graphics on the lid were updated to reflect the new design. As evident from the pictures, every component is tightly fitted, making it essential to handle the wires with care when sliding the lid over them. Please note that this enclosure is not waterproof; the PG7 gland serves as a strain relief rather than a sealant.