Espigüete Wing

thingiverse

Flying with a PLA-printed fuselage, two perimeters, and 5% infill.\r\nThe wings are cut from porexpan and covered with glued carpenter's glue-diluted paper, followed by wrapping with shipping tape, once the paper is dry. This method gives them rigidity making balloon tanks unnecessary. The flight weight with a 5Ah lipo battery is approximately 1200g, easily flying with that battery and with an 8Ah battery slightly delaying it to adjust the center of gravity.\r\n\r\nMotor: 1000kV hexTronik DT1000 brushless outrunner motor without brushes, or similar, https://hobbyking.com/en/hextronik-dt1000-brushless-outrunner-1000kv.html\r\n\r\nESC: Turnigy Plush 40A or similar, https://hobbyking.com/en/turnigy-plush-40amp-speed-controller-w-5a-bec.html\r\n\r\nPropeller 9 x 4.7 or 11 x 5\r\n\r\nhttps://www.youtube.com/watch?v=7ctjX8IQTwA