ESP32 Devkit v4 Snap-Fit Case

thingiverse

This is a Snap-Fit Case for the latest ESP32 Devkit v4, which has (compared to the Devkit v1) a smaller PCB without screwholes and where the antenna is sticking out. As far as i can tell, there are no other cases for the the Devkit v4, which i why i made a custom one. Features: - hole for status LED - two integrated buttons - snap-fit top and bottom shells - pin breakout supported (male & female) - both STL's and FreeCAD files Configuration: - fully enclosed (no pin breakout, just the bare board in a case) - pin breakout to the bottom (breadboard compatibililty) - pin breakout to the top (typically usefull for projects) ...just pick the corresponding top and bottom part for the case. Note: - Wether you want to use male or female pin headers is your choice and most likely depends on you projects configuration and needs. The dimensions in the pin-breakout allow for both, as they are of the same size. - The Snap-Fit mechanism requires some force to close and a spunger to being opened again. The tolerance is very small, so that even a small over-extrusion might make it to tight. Enjoy!