ESP32 Cam Combined board

thingiverse

I've made this box for wallmount for a combined esp32 cam (blank camera is also shown on the picture). Not sure if all of these sold are within the same measurement, so I uploaded the fusion360 file. All parts/bodies are seperated by 0.1mm in this file. You can rotate the camera on two axis, which was enough for my use case. If you need more, you can construct a more complex arm for m3 screws. The camera is powered by micro usb and the two switches at the site are easy to access. I needed to clean the camera hole after printing (like 0.1mm too small), but did not want to make it bigger, since I was afraid the camera would become loose. All screws are tightened against nuts, which are in printed polygon holes. In my print they had a more loose fit.