ESP32-C3 Case

prusaprinters

Again, I haven't found a suitable case for THIS specific ESP32 variant, so I had to make my own. IT is fairly simple, prints in ~1h (0.3 layer, 3 perimeters, 10% infill), has buttons integrated in top cover and GPIO headers accessible from bottom (dupont cables can be connected). Need 2x M3 nut and 2x M3 screw (I used M3x8mm, but shorter or longer should fit too).  Different top cover versions, with and without window for LED (with bright PLA colors it is thin enough to shine through it. Also did one bit thicker, hoping it will work better.  One issue I still have, once the top cover is bolted down, it bends up on the far sides. It might need some rework in the future.