ESP12-E Wireless Clock - WS2812b housing

thingiverse

What's Up? ESP12-E / ESP8266 Board Housing with Mounts for WS2812b 12-LED Ring. Hour Hand: Red, Minutes: Green, Seconds: Blue. Since minutes are in increments of 5, I've also added "Purple Minutes" - IE if it's 7 after, you'll see the green LED on the 5 mark and two additional purple LEDs will be lit. How Can You Do It? You can make it do flashy things or use it as a wifi time synced clock. Github Source Code: https://github.com/gunkl/esp12e-clock The current binary for the clock is here: https://s3-us-west-1.amazonaws.com/ds01222018-mypublicbucket/public/esp-clock12.ino.bin You can set the wifi ssid and password as well as UTC offset by following the menu system via the serial console. Connect at 115200. I used the HiLetgo WS2812b 12-LED ring obtained from Amazon. Connect GPIO14 to the DI wire on the LED ring. Use standard resistor and cap wiring for power (+Vin to 330ohm resistor to LED+, GND to LED, 63+uF cap from +Vin to Gnd). Currently No Daylight Savings Automatic Support. No Echo-Back on serial during config, so be prepared to enable local echo. Add Daylight Savings Support. Make a new lid design that's a little more aesthetically pleasing.