ESP-01F programmer

thingiverse

# ESP-01F programmer Due to the lucky fact than all pins needed to flash are in the same side of ESP module, I've designed a simply "bed" with all necessary connections. Because of the size of the module, connections are too close, so I've decided to split them in "upper horizontal" ones and "lower vertical" others. Each group is in one piece of the model. I've used 1mm pogo pins inserted by pressure in models with enough room for wire soldering. In the floor of the bottom model there is a window to insert a 2x4 connector of male pins. I've used in this connector the same distribution that ESP01(S) has, so you can use an ESP01 usb programmer if you have one. Of course you can connect any programmer wiring it to apropiate pins. The two parts of the model must be joined and the result has two possible vertical positions: Upper position: where lower vertical connections are hidden so you can easily insert or extract the ESP-01F module Lower position: where lower vertical connections can touch the ESP`01F pins. This is the programming position. Push down top model to go to lower position. Open bottom model arms and pull up top model to go to upper position.