Eryone Thinker S Levelling Sensors

thingiverse

These mounts allow for easy leveling of the Eryone Thinker S. With minimal design modifications, these sensor mounts can be adapted for use on other 3D printers. Required additional hardware includes: 2x M3 40mm bolts to secure the header to the hot end mount. M3 fully threaded 60mm bolts for adjusting the height of the sensor mounts. Multiple M3 Rivnuts for securing fasteners. 1x M6 Rivnut for added stability. An M6 bolt provides additional support. Several M3 washers are needed for added protection. M3 compression bed leveling springs help maintain precise alignment. To use these mounts effectively, consider purchasing the following components from Amazon: A dial gauge, available at https://www.amazon.co.uk/gp/product/B07C9MZ858. The BLTouch Probe can be found at https://www.amazon.co.uk/gp/product/B07YC9DP3J. For capacitive sensing, choose between a 9mm sensor (https://www.amazon.co.uk/gp/product/B071J1JPQV) or a 12mm sensor (https://www.amazon.co.uk/gp/product/B072C35ZDC). Compression springs can be purchased at https://www.amazon.co.uk/gp/product/B07QB78Y65. The IR Probe is available from Ooznest at https://ooznest.co.uk/product/duet-ir-probe/. To attach the dial gauge, secure its supplied mount firmly in place. To prevent rivnuts from turning loose, users may find it helpful to glue them into 3D printed mounts using epoxy resin. Thread locking mixtures can be used to lock bolts securely in position.