EQ Beta

thingiverse

EQ-Beta The EQ is a hand cranked actuation device for anything that you need actuated. Each full 360 rotation of the crank results in 5 actuations of the bumper shoe. Important Notes: **If using the Reinforcement Bracket (RE-Bracket), refer to the render and replace the M2x6 screws with M2x10 screws. Replace one of the M2x15 screws with a M2x20 Screw. (The RE brace provides more mounting stability at the expense of a little extra fiddling) * The EQ Beta clamping feature is compatible with horizontal protrusions no thicker than 2.85 mm -as an example, a milspec airsoft ar15 trigger guard would be applicable because it is thinner than 2.85mm, a MAGPUL trigger guard would not be applicable because it’s thickness is greater than 2.85mm. (The next iteration of the EQ will accommodate thicker protrusions.) * The EQ was tested and proven to be functional with an ultra realistic airsoft gun that contains a MILSPEC trigger group. The EQ has not been tested with any aftermarket trigger shoes (and will likely not be compatible) * Print the bumper shoe and 5 lug spur components with 100% infill and the remaining parts at 40-60% infill *No supports! All overhangs are accounted for, just make sure that the parts are oriented on the print bed correctly. *PETG or stronger recommended. *Lock nuts in place with blue loctite or superglue * Make sure the M2 nuts that go in the clamping geometry (on the housing component) are fully seated, use the prusa pull method. *** NOT FOR COMMERCIAL USE*** * I am not responsible for anything that you mess up. If used in a capacity to include boom sticks, smoke poles or shootin irons, make sure to follow all of your state laws! (**As of the time of this writing, crank actuators are federally legal BUT several states have outlawed them so look up your local laws regarding “trigger actuators” first before posting some dumb sh*t on facebook! You need: X1 M3 Bearing (3x6x2.5mm) *this is optional but recommended for long term use. X2 M2x15mm Screws X2 M2x6mm Screws (longer is fine you’ll just have overhang) X1 M2x10 Screw X4 M2 Washers X5 M2 Nuts X1 M3x30mm Screw X1 M3 Washer X1 M3 Nut Blue Loctite or Superglue --TangoWhiskey