Epson 1400 CIS Ink Caddy 1390 1410 Artisan 1430

thingiverse

Caddy for EPSON 1390 1400 1410 Artisan 1430 CIS ink system Instructions are clearly printed on the photos. Exercise extreme caution when removing the left panel or drilling, as it may be hot glued or epoxied in place. I personally prefer screws. I'm using a budget-friendly CIS system and this setup works perfectly well for me, but your mileage may vary. Fill the tank at 20-40% capacity, provided you have two walls (I opt for three). Any layer height will suffice. In my case, I used a high-quality silvery metallic PLA. Only the central hole aligns with the dowel pin on my EPSON 1400 model, allowing a secure 1/2" screw without any issues (10-13mm should also be suitable). Be particularly cautious if you own a similar but different model. STEP and STL files are included for your convenience, in case you need to modify the width or height. The provided "slots" serve as zip tie holders, although I didn't require them in my setup. Good luck with your project!