EPAX-X1 LCD (with Matrix LED mod kit) cooling fan duct

thingiverse

EPAX-X1 LCD (with Matrix LED mod kit) cooling fan duct. LCDs used in printers to mask UV light that cures resin are vulnerable to high temperatures, so direct cooling is essential to extend the life of the LCD. This fan duct is designed for efficient and effective LCD cooling. Important! This fan duct mode is only available for EPAX-X1 Dental edition or EPAX-X1 with Matrix mod Kit installed. Materials: * 75x30mm blower fan (12V) x 1 * 97x33mm blower fan (12v) x 1 (stronger but noisy) * 60x15 mm DC fan (12V) x 1 * 35mm M3 bolt x1 * 30 mm M3 bolt x1 (flat head) * 20mm M3 bolt x4 * M3 nut x 5 Print: * FanDuct x1 * M3BoltHolder x1 * epaxX1panelplain x1 Print "epaxX1panelplain" in the form of a mesh using the following slicer settings: -https://www.youtube.com/watch?v=6PVeh43Or-g How to Install: 1. Remove the bottom and back plates of the printer. 2. Remove the Matrix LED and LED Mount. 3. Remove the 60x15mm cooling fan for side exhaust. 4. Combine fan duct and 75x30mm(or 97x33mm) blower fan. -First insert the printed M3BoltHolder into the bolt hole of the blower fan. If it does not work, grind it to sandpaper. -Fix the fan to the duct using a 30 mm M3 bolt. 5. Install the duct + blower fan inside the printer. 6. Secure the duct and fan to the printer using the 35 mm M3 bolts and nuts. Be careful not to damage the blower fan. 7. Connect the wires of the side exhaust fan to the wires of a 75x30 mm blower fan and a 60x15 mm DC fan. 8. Fix two 60x15mm DC fans to the printed epaxX1panelplain. Make sure the sticker (the wind direction) faces the outside of the printer. 9. Refit the Matrix LED and LED Mount. Be careful because space is narrow. 10. Incorporate epaxX1panelplain into the printer. 11. Combine bottom plate after wires are cleaned. 12. Complete.