Enhanced Dual Ducts for iFlight MegaBee v1

thingiverse

This is an upgraded dual duct designed specifically for the iFlight MegaBee (original v1 version). Its angular aerofoil shape and precision-crafted tolerances allow it to seamlessly integrate with uncut 3-inch ducts, resulting in substantially more lift than the standard ducts supplied with the quadcopter. By connecting the front and rear ducts in this manner, vibrations are significantly reduced. To utilize this setup, pair it with regular, uncut 3-inch props - the HQProp Durable 3X4X3 V1S is a recommended choice. Due to the extremely tight tolerances, the props will initially scrape slightly when new, but this issue resolves itself quickly as they wear down and balance out within seconds of flight. Simply arm the quadcopter, initiate spinning, and engage roll and pitch while still on the ground for automatic prop balancing. For optimal results, print these ducts using PETG. Supports are only required overhangs exceeding 60 degrees; smaller overhangs will generally print without supports on most printers.