Endoscope + ABL = EndABL(Creality Ender 3 Pro or similar)

thingiverse

For now this thingy is finished. I have found 15 degrees good for a standard E3DV6 with a standard block. A volcano will need the 7 degrees. Not sure what 30 degrees will be good for since its basically looking at a theoretical V6 heatsink. But they are all up and have been tested. Ive found the LEDs on the endoscope are very adequate. I have them turned down just a bit since they bleed out the video feed if too close to transparent or anything reflective. ***Update 12-9-20. Just added two tweaked versions of a severe 30degrees and a more modest 7 degrees. M3 bolt to secure ABL. M2/M1.5 to secure Endoscope. Mark2 Version1 is 30 degrees. Mark2 Version2 is 7 degrees. Mark2 Version4 is 15 degrees which is being streamed printing Christmas presents.*** ***Update. Live testing of the endoscope camera can be found here. Need to do adjustments before its angled right but the FPS is good. https://youtu.be/6ho84I5DBdY**** Remixed the 18mm sensor holder to also have a spot for a 7mm LED endoscope in a vertical orientation using the mirror attachment. I would recommend drilling a small hold on the side of each hole to allow for a M3 screw to secure each part. I will upload pics later. Endoscope used https://www.amazon.com/gp/product/B08FBVMV7G/ref=ppx_yo_dt_b_asin_title_o04_s00?ie=UTF8&psc=1