Endgame Oculus Quest Headphone Mount

thingiverse

Very sturdy headphone mount for Oculus Quest using Porta Pro driver. It is compatible to both the stock Oculus Quest strap and [GoQuest's Halo Strap v3](https://www.goquestvr.com/index.php/product/halo-strap/). The arm can be adjusted to any angle while the actual driver can be pushed into the ear by turning the screw. When not in use, the arm can be stowed upward or easily removed altogether to keep out-of-the-way. Find the section below that corresponds to your Oculus Quest's strap and follow the instructions therein. # Instructions ## Stock Oculus Quest Strap **Needed materials:** - 2x M5 nut - 1x M5x16 bolt - [PortaPro headphone speaker drivers](https://www.aliexpress.com/item/32487669152.html) **Things to print:** - 2x Knob.stl - 2x Oculus Quest OEM Strap Bracket.stl - 2x Arm.stl - 2x Screw - 2x PortaPro Screw Cap Only the screw cap requires a support placement touching the build plate. Everything else can be printed as is. **Assembly:** The parts list in this thing's images show the order in which the parts should be assembled. 1. Insert the M5 Nut in the bracket and then attach it to the Oculus Quest. 1. Insert the M5 Nut inside the knob, followed by the M5x16 bolt. 1. Place the arm in-between the bracket and knob, then loosely tighten using the knob. 1. Insert the printed screw into the arm. 1. Insert the screw cap onto one end of the newly inserted screw. It might be a tight fit, but once inserted, it should allow the screw cap to fully rotate without much friction. 1. Attach the Porta Pro driver into the screw cap. 1. Repeat the previous steps for the other side. ## GoQuest Halo Strap v3 **Needed materials:** - 2x M5 nut - 1x M5x16 bolt - 1x M3 nut - 1x M3x12 bolt - [PortaPro headphone speaker drivers](https://www.aliexpress.com/item/32487669152.html) **Things to print:** - 2x Knob.stl - 1x GoQuest Halo Strap Bracket (Left).stl - 1x GoQuest Halo Strap Bracket (Right).stl - 2x Arm.stl - 2x Screw - 2x PortaPro Screw Cap Only the screw cap requires a support placement touching the build plate. Depending on your printer's capabilities, the brackets may also need build plate support. However, I found I didn't need one for my Ender 3 Pro. Everything else can be printed as is. **Assembly:** The parts list in this thing's images show the order in which the parts should be assembled. 1. From the halo strap, remove the screw and plastic cap from the joint connecting the front and rear halves. 1. Insert the M5 Nut in the bracket. 1. Attach the bracket into the halo strap beam. The guides in the bracket should slot in to the contours of the halo strap. Insert the M3 nut on one side of the bracket and secure it in place by screwing in the M3 bolt. 1. Insert the M5 Nut inside the knob, followed by the M5x16 bolt. 1. Place the arm in-between the bracket and knob, then loosely tighten using the knob. 1. Insert the printed screw into the arm. 1. Insert the screw cap onto one end of the newly inserted screw. It might be a tight fit, but once inserted, it should allow the screw cap to fully rotate without much friction. 1. Attach the Porta Pro driver into the screw cap. 1. Repeat the previous steps for the other side.