Ender6 Hot End Bowden Wire Bracket, Brace, Support, Mount (No re-Wiring!)

thingiverse

This is my first design! I couldn't find a support for my bowden/wires that I liked. I also didn't want to have to rewire everything just install a mount. I made this one with that in mind. Squared off from end to end for a clean fresh look. You will need different screws for this mount, I used M3 .5 Hex 35mm(Length). They do stick out past the extruder bracket about 5mm, so a 30mm fastener would be better. Notes: The tolerances for this are very tight, I took a drill bit to ream the screw holes and the Bowden hole. (This is my first printer and it's still stringing a lot so it may be just because of that.) You don't have to ream them out you would just have to screw for awhile to get the screw to the back of the block. I searched everywhere for something like this and I couldn't find anything that matched what idea I had in my head, so I created this. Hope you enjoy! This is on an ender6 but they didn't have ender3 in the options when uploading.