Ender3V2 Z-Stop

thingiverse

My Ender3V2 Z-end stop broke due to my own stupidity! One convenient way of adjusting the bed i found was not to mess with the bed screws but instead changing the position of the sensor for the new nozzle. So i broke it while installing the last one (not recommended). Parts needed are: The original switch & all original screws 1 new printed Z-end stop (100% infill) 1 M4x25 Allen Socket Head Screw 1 3mm Allen key The Allen screw goes into the hole on the bottom - it should tap itself in with a little effort. To fine adjust the Z distance once you are in the right ballpark (the pitch of an M4 screw is 0.7mm): a 1/4 turn moves you 0.175mm up or down a 1/8 turn moves you 0.0875mm up or down I hope it helps you as it helps me.