Ender3 Feet for Prusa i3 Lack Enclosure

thingiverse

I was able to take the feet, lengthen them vertically about 30mm or so, and this gave me enough space on a standard Prusa i3 lack enclosure to fit the Creality Ender3 without any other modifications. If you like the original design it's very minimalistic, and these feet aren't the ideal solution, but they're very simple and only require a few wood screws to hold them in place. Later I added slots for recessed screws along the outer edges of the feet instead of just in the center. Also, I punched a hole through the center to allow for a longer screw there if you prefer (closer to the original design). Simple, no frills, and leaves a gap under the base, but to repurpose an i3 built lack enclosure the simplest thing I could come up with.