Ender3 / Ender3 Pro Wire Management

thingiverse

I created this organizer specifically for managing the extruder and hot end cables. It also includes a convenient wire holder, ideal for users with metal drive feed kits. The tower should be installed at a distance of 22mm from the z-axis motor to ensure proper alignment. To secure it in place, use five 8mm bolts. For the wire holder, a single 16mm screw will suffice. The cable clamps are strategically positioned at both the top and bottom of the tower to prevent any rubbing against bed wires. Finally, a few gentle cable ties neatly securing the extruder and hot end wires complete this setup. If the cable clamps seem too tight, simply verify that the ribbon cable hasn't slipped into the gap between the clamp and the tower. Have fun experimenting!