Ender Jet Cooling Duct Remix

thingiverse

This is a Remix of Ender Jet Cooling Duct, it also fits CR-10, 10S, S5, among others. I did a remix on these two because there was a gap, an opening between two walls. In the top half of the included picture (the 3 version is on left, the 4 version on the right) the gap is circled in red. In the bottom half of that picture where it is circled in yellow, the gap is filled in (filleted). Also there is a picture showing a piece of paper slipped in the gap. It might be that the mesh is just too thin there, I didn't look closely at the mesh, that the slicer ignores it. It's sliced using Simplify3D and the Extrusion Width is 0.35mm, thin enough I would think to print if it was there.