Ender Foot - No Supports

thingiverse

Hello I have remixed this print to work without supports so that it may be printed in the strong orientation. This is the 35mm tall riser. I liked the style of the open webbing on Lightweight Version A from the original, but it was difficult to print without supports. I edited this in blender to make the openings into circles so that each layer progressively bridges the opening. I also removed one edge of where the rubber foot actually goes. This eliminated any need for support material. I have tested and the rubber foot still has enough squish to fit as well as the adhesive to hold it in place so no worries of it slipping out. Also recommend printing with a high # of perimeters ( I went with 7). It really cuts down on infill and I think it helps with strength.