Ender Extender (400) Storage Bin

prusaprinters

If you have installed the Ender Extender 400 kit, this fills in the huge empty space on the front right of the printer with a useful storage bin. It mounts using M3 hardware and T-nuts; there is room left for the display ribbon cable to pass around it. Will fit on a 220x220mm build area if you disable any raft, brims, or skirt.A mat insert is also included, for printing with TPU. To give a nice non-slip surface to the floor of the bin.Print settings:Material is at your discretion. I used PETG for the bin, and TPU for the mat.Layer height is also at your discretion however I designed the bin for a 0.24mm layer height, and the mat for a 0.12mm layer height.Recommend 0.5mm line width as many of the dimensions are a factor of 0.5mm thickness.Recommend tree supports, touching build plate only.Installation:Use M3 screws with T-nuts to populate the holes. For the side with 4 stand-offs, I only used 2 of them but it gives you some options.Offer up the bin from the bottom, as the end with the tab flange is going to the bottom of the Y-axis extrusion. Be careful of the display ribbon cable - depending on how you routed it, ensure it is not pinched by the standoffs. There is space for the cable to run between them.