Ender D1 Structure for E5 S1 Acrylic Top Cover Mod - UPDATED

grabcad

I created a structure to hold the acrylic cover that fits the E5 S1 to fully enclose it in order to print ABS parts that are bigger than the Ender V1 can handle.The run-out sensor is now mounted inside the cover and has the universal joint as the E3 S1 Pro. There is slot in the top cover sensor housing so that the spool feed to the sensor is not affected by opening the cover.The external hinge components are supported by reinforcing braces on the inside of the cover to protect the acrylic cover from stress at the screw holes.The sections interlock via an oblique junction and tongue and groove connection which adds strength the frame for rigidity and to support the open cover, which is also supported by the design of the centre hinge component.There are two versions of the front centre section of the top frame so that you can have the Ender logo revealed or not.There is also an x-axis limit switch stopper to stop the movement a little short of the left side frame wall, but you may not need it at all.