Ender 6 with DDXv3 Bondtech Cable Chain Mount

thingiverse

I put a Bondtech direct drive extruder (link below) on my printer. And also wanted to install Chain Cable. I did not find suitable fasteners, since they are attached from the side of the wall. Therefore, I developed my own mount. The mount is installed on the standard mounting screws, but on the reverse side of the hotend. From the side of the wheels. The wheels don't hurt, don't worry about it. You will need shorter screws, used those that remained after installing DDX. The rear mount is also installed in the regular places under the screws. There are holes on the back, you can fix the wires with ties. The mount is suitable for Chain Cable R18 10x20mm (link below) Only now I found the time to print and install it all. After printing, I found that there are stoppers on each link of the chain so that the chain does not bend in the other direction. There are no cavities for these stoppers on my model. so I cut off from the back link of the chain (there is a photo that needs to be cut off). It was easier than redesigning the model and re-printing. If you need a corrected model so as not to cut off the stoppers manually - write to me, I will fix the model faster. Bondtech® DDX™ v3 For Creality: https://www.bondtech.se/product/bondtech-ddx-v3-for-creality-ender-cr-10s/ Cable Chain: https://www.aliexpress.com/item/1005001795469984.html?spm=a2g0o.9042311.0.0.3e324c4dvvzzQ0 I use R18 10x20mm open (It took 29 chain links) 03.26.2022 update I installed the top cover on the printer and began to print at higher temperatures. This caused the front to be too soft as it was made from PLA (don't use PLA for this part!). Because of this, the chain could come off the mount. So I redid the front. The new version is easier to remove and install, as well as more rigid due to several connection planes. Printed out a new part from PETG.