Ender 6 OctoPi Stand

thingiverse

Quick stand to support an OctoPi without any special hardware. V1 was a first draft. It's tight between the USB ports and the vertical V-slot rail. It's also a bit short which makes plugging in the power cable difficult unless you have a right angle cable. V2 shifted the Pi to the left for better access to the USB ports. This crowds the SD slot a bit, but if you're using Octoprint you don't need the SD card as much. V2 also uses 2 screws to hold the base in place. The Pi is held to the stand with standard M2.5 standoffs threaded directly into the PLA. The stand is held in place using one or two of the Ender-6 base plate screws. This design works great with smaller screens. However, I abandoned further development of this to focus on an Octopi stand that mounts to the vertical V-slot rail using M3 screws and T-slot nuts. https://www.thingiverse.com/thing:4902560 Yes, I edited the Creality display firmware to change the icons ;)