Ender 6 cable chain

cults3d

With this mod you can put a cable chain for Ender 6 if you have installed a Matrix or Hemera engine with my own mod (https://cults3d.com/en/3d-model/tool/matrix-hemera-ender-6-mune1) if you already have the indicated model printed you will simply have to print the pieces of this kit and buy a 1000 mm cable chain (10x10 mm, R28). This is an easy process but you will have to be patient as it is somewhat slow and painstaking as the cables fit just right. Print the kit mods 3.Put all the wires inside the conduit, if possible disassemble everything and leave them inside already to simply install. Fit the rear bracket, you will need T-M3 nuts, M3 screws to anchor it to the profile, and some flange, you will have to put all the cables already tucked into the trough, previously anchoring the first link to the piece with M3 screws and nuts. 4.About 60cm of trunking is used. 5.Repeat the process at the front, placing everything and leaving the wires well placed, taking advantage of bringing the wires further back towards the plate. 6.Place the front cover which also acts as a cover flange. 7.Check if you have left the gutter long or short. If everything is OK connect everything and test, it should run very smoothly. 9.OPTIONAL it is recommended to weld knurled nuts in order not to wear the thread, although it is not necessary. 10.OPTIONAL it is recommended to fit JTS terminals. for quick connection of fans 11.The models shown in the photos are versions for linear guides and versions without updating, the models included are tested and working, any doubt connect with me and I would modify without problems.