Ender 6 BTT Octopus driver cooling duct- Remixed

thingiverse

In an effort to bring more fresh air into the air circulation constrained electronics bay of the Ender 6, I added a round duct to the 5015 fan intake. The plan is to use a step drill to create a large 30mm ish hole in the top plate of the electronics bay directly above the duct with a step drill, and cover it against debris entry with a magnetic mesh filter. I got the DEMCiflex round 60mm from Titanrig on Ebay. Hopefully this will introduce enough fresh (possibly cooler) air to the bay to allow me to use it with the bottom plate attached. Should be used with the mount from the thing this was remixed from, or the Octopus Pro remix of it. If you use a step drill bit to create your own hole in the deck sheet metal of your own Ender 6, please proceed with caution as step drill bits are not the easiest drill bits to control. Slow and steady will make the drill a lot less likely to yank itself free of the hand of the driller. I printed with the round duct facing up.