Ender-6 Biqu H2 Mount - HACKED

thingiverse

First thanks to designbydave for the original part. I had two requirements that prevented me from using it as is, hence this remix. 1. I wanted to use a 5015 duct and BL Touch - https://www.thingiverse.com/thing:4901193. The lower "arm" prevented mounting of it. 2. I wanted to use this cable chain - https://www.thingiverse.com/thing:4731935. The original part uses the top two screws for mounting where the cable chain mount would go. So I chopped the upper part off also. 3. The original part was close to the end stop terminals on the X carriage, so I trimmed down that side of the original part. Stabilty of the Biqu H2 mounted using only one arm with two screws seems adequate. Mounting of this plate to the X carriage uses only two screws which also seems sufficient. It is ugly but functional.