Ender 5 Rear Mount Electronics & Power Bracket

thingiverse

This is a bracket for mounting the bottom electronics and power supply box on the Ender 5's rear so you can open it without turning the unit over. When fitting an SKR 1.3, you won't need to change any cables, but a longer screen cable is recommended. This still allows for enclosing it using the 2020 slots and also allows for much easier and cleaner cable management. You can use up to five of these brackets; six if you move the power switch. I suggest printing the largest corner brackets to reenforce the frame after removing the box from the bottom and using 2020 clips for cable management. I printed this bracket on the side that sits against the box, but when I printed it laying on the support angle side, it had a lot of stringing due to the 65 degree overhang. I used many layers and supports and it might stiffen things up, but you don't need to do that.