Ender-5 rear mount

thingiverse

Mount the electronics case vertically inside the back frame using brackets. Requirements: - Use 4 M5 screws; those from the case will do, though they're a bit long. Install: - Unplug the power cord. - Remove the 6 screws from the electronics case. - Slide it to the right side through the frame and into place at the back (or simply detach the cables). - Secure the bottom bracket with two M5 screws. - Place it in the frame, starting with the top part first (tilted forward), then let it slide down. - Insert parts A and B from the left into position; if stuck, just wiggle them a little. - Ensure the power cord is removed before proceeding. - Open the electronics case and have one hand below the cover when you remove the final screw as it can drop quickly (it has a fan cable attached which might tear). - Loosen the power cord socket and push it slightly outside (top left, two screws from the outside) since this obstructs the screw hole. - Insert the top two screws; no need to tighten them much, they just hold the brackets in place. - Replace the power cord socket and cover.