Ender 5: rear electronics housing assembly

thingiverse

Simple brackets are required for hanging an Ender 5 black box at the back of the printer. These brackets should fit tightly into 2020 profiles, possibly requiring some light sanding to ensure a snug fit. After this modification, the case is positioned vertically, with all cables fitting without issue and access to the SD card slot and USB preserved. The LCD panel must be mounted in the right rear corner; otherwise, you will need to replace the ribbon cable with one that is longer. A distinct gap exists between the case and Ender frame, eliminating concerns about case cooling if you plan to build a closed chamber for high-temperature printing. The bottom of the frame remains free for further modifications, such as installing a dual Z-axis set. Printing requires creating two identical brackets for the down side of the box and one for the screw near the USB and SD card slot. You will also need at least three M5 screws that are 10mm long and three nuts. Assembly involves screwing all brackets to the box, positioning the box on the back of the printer, marking the position of the brackets onto profiles, then unscrewing the box, screwing in the brackets, and mounting the box again.