Ender 5 psu shim for noctua fan 60x60x25

thingiverse

Wedge to raise the ender 5 power supply cover. These shims were made to replace the noisy fan of the power supply by a 60x60x25 noctua. The noctua being higher than the old fan, it was necessary to slightly raise the power supply cover. You will need to use M3 screws. Personally I used four: M3:4 and four: M3:8. There is however a small defect to that, the cover of ender does not close perfectly, but this is invisible, because it is located below the printer. WARNING: Touching the power supply is very dangerous and not recommended, you do this at your own risk. I do not guarantee that these shims are not dangerous.